Sunday, May 24, 2015 5:04:38 PM Sorten
lective purposes. The plants are usually placed in separate pots and
go through their entire life cycle within the cabinet environment.
Clones are taken from the plants and placed either on a second shelf in
the cabinet or near a window in your house. Some people have made a
small compartment in their cabinet for clones and germination. This
can be any size, but is kept small because you only want to just keep
the clones alive. This small compartment will probably have one or
two fluorescent lights in it for the clones. It would be best to keep the
compartment at the top of the grow chamber near the exhaust fan. You
do not need an intake fan for these clones unless it is a big set-up. A
simple hole in the side will allow the plants to breathe. After the
harvest, these clones are put into the grow room and the process is
repeated. It is a Perpetual Grow. The legal term is a Marijuana
Factory. You can harvest bud every 30 days if you have the right
Your light can be air-cooled in a few ways. The most common
way is to mount a 4" dryer flange on the hood and link from the hood
flange to the exhaust fan flange with a 4" dryer hose. A fan can be
mounted on the hood also.
Figure 8.5 - This is a picture of a typical air-cooled system that can be
purchased in most grow shops that sell grow lights.
Figure 8.6 - Nice Frosty Bud by 'A Merry Caner'.
As you can guess all of the above grow methods can be
shaped to suit the grow room. Many a cannabis cultivator have turned
entire rooms into a ScrOG or SOG grow. Size is totally up to the
grower. For those who are happy with 4 ounces of dried bud every
month a small SOG or Cabinet grow is the way to go. For those who
want a bigger yield to last all year then a large ScrOG grow may be
considered. Many a 5-ft. x 5-ft. ScrOG grower have delivered 30 to 50
ounces of Marijuana every 2 months. When conditions are at their
optimum level this can be achieved.
An expert's indoor grow room would look something like this.
14-ft. x 24-ft. area x 9-ft height. Several vertically suspended HPS
lights would hang from the ceiling. The roof, walls, and floor would be
covered in reflective material like flat white paint and Mylar. All
lighting fixtures would be met at a junction box on the wall. Ballasts
would also be attached to the wall. The plants would be placed on the
ground in large container buckets inter spread between the lights
hanging down. The room would also be completely light proof.
Multiple air ducts and extraction fans would take the hot air
out and pull the fresh air in. An Ozone generator would be in place to
kill the smell and cannabis odor. Other items may be in place such as a
CO2 generator, electrical generator, and even a light mover like a
Light Rail III. A Light Rail is a horizontal light mover and there is a
‘Sun Circle’ that the lights suspend from that move the lights in a
circular pattern. This allows fewer lights to
Based on the observation that cannabidiol (12) gives mainly t,1_THC (1) on
treatment with BF3'EtzO/CH2Clz, whereas under the same conditions 11 and
6 give t,6-THC (2), Razdan and co-workers concluded that the formation of 2
and not 1 must be due to the acid being generated from a mole of H20 and